how to install a slave hard drive on windows xp Performance and Maintainance of XP ... I'm having trouble, the bios has detected the slave drive but I cant find it, can someone help me????

For each cable, if there are two devices on it, one should be Master, and one should be Slave according to the jumpers. Keep this in mind when installing your new hard drive.

If the drive has been pulled it out of another system I will give you some clues on where to look for jumper settings. ... MA=master is disk 0 on the IDE channel, SL= slave is disk 1 on the IDE channel,

DS means "drive select" and is used to set the drive as master. SP means "slave present" and sets the drive to slave. It is used when another drive is set to DS. CS is "cable select".

To add a second hard drive as a Slave Drive, the first thing to do is shutdown the computer, set the jumpers on the back of the new hard drive to Slave, and mount it in the case.

(Drive integrity will be verified); In this display you will set the size of the Logical DOS Partition. Type 100% and press Enter.

If the software requests the next sector after the processing-delay, that next sector may have already rotated away under the drive's read/write head, and thus it will take an extra revolution of...

Home > Computer, Hardware > Installing 2nd IDE drive as Master / Slave Configuration using jumpers

Jumper the master [original] drive to Master, and the new drive to Slave. Check for jumpers on the back of the drive.

Data Recovery Tutorial: How to Slave a Hard Drive ... In fact having restore disks greatly eases the burden of re-installing everything.